Non-Slip Media Polypropylene 5lb.

From: $35.95

Non-slip media that can be added to any of our surface sealers.

Description

Non-Slip media for concrete floors

Polypropylene based non-slip clear sealer additive. This micro-sphere additive can be used with any of our surface sealers. Our non-slip media can be used on interior and exterior sealed concrete where a non-slip surface is desired such as walkways, patios, garage floors, driveways, and lobbies.

The micro-sphere shape of the additive make it softer on bare feet and easier to clean compared to broadcast sand.

Application: Portion out and slowly mix into the gallon of sealer. Make sure each gallon gets the same amount for a consistent look. This can be done in a mixing bucket if needed. Blend in slowly to prevent clumping and an even broadcast throughout. The five pound bag can treat up to 25 gallons of sealer but you can add as much or as little as desired. The more that’s added the rougher the surface will be. Wear safety goggles and respirator during application.

Tips: When adding the coarse (20 mesh) to thinner sealers like Barrier EXT and Poly Shine it’s recommended to add the media to the first coat and roll on as usual. The second and third coats will help lock the media into the sealer.

For the other grit levels it’s recommended to add the media into the final coat and roll on like usual.

The more you add the more it will matte out the look of the sealer. Adding the fine (100 mesh) is best at giving the sealer a matte finish look.

Additional information

Weight 5 lbs
Mesh Size

100 Mesh, 20 Mesh, 50 Mesh

You may also like…